TE0741 Series-Xilinx Kintex-7, Flash, 8 High Speed Serial Transceivers, 25 MHz Oscillator（70T/160T/325T/410T ）

The Trenz Electronic TE0741 Series is a FPGA module integrating a Xilinx Kintex-7T FPGA, 8 MGTs (Multi Gigabit Transceivers) and 32 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/Os is provided via rugged high-speed stacking strips.

All this on a tiny footprint, smaller than a credit card, at the most competitive price. Modules in 4 x 5 cm form factor are fully mechanically and largely electrically compatible among each other.

Key Features

• Xilinx Kintex-7（70T/160T/325T/410T ）
• 256 MBit (32 MByte) Quad-SPI Flash memory (for configuration and operation) accessible through:
  • FPGA
  • JTAG port (SPI indirect)
• 8 MGTs (multi gigabit transceivers)
• FPGA configuration through:
  • JTAG (B2B connector)
  • SPI Flash memory
• 25 MHz low jitter oscillator with shutdown control
• Programmable quad clock generator (Silicon Labs Si5338)
• On-board high-efficiency DC-DC converters
  • MGT voltage regulators with control enable
  • Core voltage regulators: up to 30 A (variants depend)
  • Supply voltages: either 3.3 V or 3.3 V and 5 V
• Plug-on module with 2 x 100-pin and 1 x 60-pin Razor Beam High-Speed hermaphroditic Terminal/Socket Strips (regular 4 mm)
• Up to 144 (94 for 70T) single-ended FPGA I/O pins available on B2B strips
• 2 user LEDs, 1 DONE FPGA pin LED
• AES bit-stream encryption
• Evenly spread supply pins for good signal integrity

Scope of Delivery

• 1 x TE0741-04-A2C-1-A Trenz Electronic 4 x 5 cm FPGA module with Xilinx Kintex-7 70T
• 8 x screws
• 4 x bolts

TE0720 GigaZee Series

The Trenz Electronic TE0720 GigaZee Series is a SoC module integrating a Xilinx Zynq Z-7014S, a Gigabit Ethernet transceiver, 1 GByte DDR3 SDRAM, 32 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

This device contains a single-core ARM Cortex-A9 processor and represents the lowest cost entry point to the scalable Zynq-7000 platform.

Key Features

• Rugged for high shock and vibration
• Single-Core ARM Cortex-A9 MPCore up to 766MHz
• 10/100/1000 tri-speed Gigabit Ethernet transceiver (PHY) with SGMII
  • SGMII accessible on a board-to-board connector
  • MAC Address EEPROM
• USB 2.0 high speed ULPI transceiver
• 1 GByte (32-bit) DDR3 SDRAM
• 32 MByte QSPI Flash memory
• 8 GByte e.MMC (optional up to 32 GByte)
• Plug-on module with 2 x 100-pin and 1 x 60-pin Razor Beam High-Speed hermaphroditic Terminal/Socket Strips (regular 4 mm)
• 152 FPGA I/O's (75 LVDS pairs possible) and 14 MIO's available on board-to-board connectors
• On-board high-efficiency DC-DC converters
  • 4.0 A x 1.0V power rail
  • 3.0 x 1.5V power rail
  • 3.0 A x 1.8V power rail
• Temperature compensated real-time clock (RTC)
• 3 user LEDs
• System management and power sequencing
• eFUSE bit-stream encryption
• AES bit-stream encryption
• Valid MAC Address and 2K serial EEPROM
• SHA-256 authentication chip with unique serial number
• Evenly-spread supply pins for good signal integrity

Scope of Delivery

• 1 x TE0720 GigaZee series Trenz Electronic 4 x 5 cm SoC Module
• 8 x screws
• 4 x bolts

TE0720－SoC Module with Xilinx Zynq 7020-1Q Automotive, 1 GByte DDR3, low profile

The Trenz Electronic TE0720-04-61Q33ML is an industrial-grade SoC module integrating a Xilinx Automotive Zynq-7020, a Gigabit Ethernet transceiver, 1 GByte DDR3 SDRAM, 32 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

All this on a tiny footprint, smaller than a credit card, at the most competitive price. Modules in 4 x 5 cm form factor are fully mechanically and largely electrically compatible among each other.

Key Features

• Xilinx Zynq XA7Z020-1CLG484Q (Automotive)
• Rugged for high shock and vibration
• ARM dual-core Cortex-A9 MPCore
• 10/100/1000 tri-speed Gigabit Ethernet transceiver (PHY), SGMII accessible on a board-to-board connector
• USB 2.0 high speed ULPI transceiver
• 1 GByte (32-bit) DDR3 SDRAM
• 32 MByte QSPI Flash memory (for configuration and operation)
• 8 GByte e.MMC (optional up to 32 GByte)
• Plug-on module with 2 x 100-pin and 1 x 60-pin Razor Beam High-Speed hermaphroditic Terminal/Socket Strips (low profile 2.5 mm)
• 152 FPGA I/O's (75 LVDS pairs possible) and 14 MIO's available on board-to-board connectors
• On-board high-efficiency DC-DC converters
  • 4.0 A x 1.0V power rail
  • 3.0 A x 1.5V power rail
  • 3.0 A x 1.8V power rail
• System management and power sequencing
• eFUSE bit-stream encryption
• AES bit-stream encryption
• Valid MAC Address and 2K serial EEPROM
• SHA-256 authentication chip with unique serial number
• RTC, temperature compensated
• 3 user LEDs
• Evenly-spread supply pins for good signal integrity

Scope of Delivery

• 1 x TE0720-04-61Q33ML Trenz Electronic 4 x 5 cm SoC module with Xilinx Zynq-7020 (Automotive)

TE0715－SoC Module with Xilinx Zynq 7030-3E, 1 GByte DDR3L, 4 x 5 cm

The Trenz Electronic TE0715-05-73E33-A is an industrial-grade Xilinx Zynq-7030 System on Module with 4 MGT Links, a Gigabit Ethernet transceiver, 1 GByte DDR3L SDRAM, 32 MByte SPI Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/Os is provided via rugged high-speed stacking strips.

All this on a tiny footprint, smaller than a credit card, at the most competitive price. Modules in 4 x 5 cm form factor are fully mechanically and largely electrically compatible among each other.

Key Features

• Xilinx Zynq XC7Z030-3SBG485E
• Rugged for shock and high vibration
• ARM dual-core Cortex-A9 MPCore
• 10/100/1000 tri-speed gigabit Ethernet transceiver (PHY) with SGMII
• MAC Address EEPROM
• USB 2.0 high-speed ULPI transceiver
• 32-bit-wide 1 GByte DDR3L SDRAM
• 32 MByte QSPI Flash memory (with XiP support)
• Programmable Clock Generator: Transceiver Clock (default 125 MHz)
• Plug-on module with 2 x 100-pin and 1 x 60-pin Razor Beam High-Speed hermaphroditic Terminal/Socket Strips (regular 4 mm)
• 132 FPGA I/O's (65 LVDS pairs possible) and 14 PS-MIO available on board-to-board connectors
• 4 GTP/GTX Tranceivers
• On-board high-efficiency DC-DC converters:
  • 4.0 A x 1.0V power rail 
  • 3.0 A x 1.5V power rail
• Temperature compensated RTC (real-time clock)
• System management
• eFUSE bit-stream encryption
• AES bit-stream encryption
• User LED
• Evenly-spread supply pins for good signal integrity

Scope of Delivery

• 1 x TE0715-05-73E33-A Trenz Electronic 4 x 5 cm SoC module with Xilinx Zynq-7030 (extended temperature range)
• 8 x screws
• 4 x bolts