Products with Xilinx FPGA

Previous Next
Products with Xilinx FPGA

TE0841｜Xilinx Kintex UltraScale Series

TE0841 Series－Xilinx Kintex UltraScale, DDR4, Flash, 8 x GTH Transceiver(KU035, KU040)

The Trenz Electronic TE0841 Series is a FPGA module integrating a Xilinx Kintex UltraScale KU035 / KU040, 2 GByte DDR4 SDRAM, 64 MByte QSPI Flash for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

All this on a tiny footprint, smaller than a credit card, at the most competitive price. Modules in 4 x 5 cm form factor are fully mechanically and largely electrically compatible among each other.

Key Features

  • Xilinx Kintex UltraScale Series
  • Rugged for industrial application
  • Size: 40 x 50 mm
  • 3 mm mounting holes for skyline heat spreader
  • 2 banks of 1024 MByte DDR4 SDRAM, 32bit wide memory interface (each DDR 16bit separate)
  • 64 MByte (512 MBit) SPI Boot-Flash
  • B2B Connectors: 3 x Razor Beam High-Speed Hermaphroditic Terminal/Socket Strips (regular 4 mm), total 260 terminals
    • 60 x HR I/Os
    • 84 x HP I/Os
    • Serial transceiver: GTH 8 lanes (TX/RX)
    • 2 x MGT external clock inputs
  • Clocking
    • Si5338 - 4 output PLL, GT and PL clocks
    • 200 MHz LVDS oscillator
  • Power
    • All power supplies on board, single supply operation supported.
    • User defined IO-Bank power
  • Evenly spread supply pins for good signal integrity.

Scope of Delivery

  • 1 x TE0841-02-31C21-A Trenz Electronic 4 x 5 cm FPGA module with Xilinx Kintex UltraScale XCKU035 (commercial temperature range)
  • 8 x screws
  • 4 x bolts

  產品編號：

TE0841-02-31C21-A：Xilinx Kintex UltraScale KU035, 2 GByte DDR4, 4 x 5 cm

TE0841-02-41C21-A：Xilinx Kintex UltraScale KU040, 1C,2 GByte DDR4, 4 x 5 cm

TE0841-02-41I21-A：Xilinx Kintex UltraScale KU040, 2 GByte DDR4, 4 x 5 cm

TE0841-02-32I21-A：Xilinx Kintex UltraScale KU035-2, 2 GByte DDR4, 4 x 5 cm
  線上商店： 購買連結 可線上刷卡/享運費補助！
Previous Next
Products with Xilinx FPGA

TE0841｜Xilinx Kintex UltraScale KU040, 2 GB ,low profile

TE0841－Micromodule with Xilinx Kintex UltraScale KU040, 2 GB DDR4, 4 x 5, low profile

The Trenz Electronic TE0841-02-41I21-L is an industrial-grade FPGA module integrating a Xilinx Kintex UltraScale KU040, 2 GByte DDR4, 64 MByte QSPI Flash for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

All this on a tiny footprint, smaller than a credit card, at the most competitive price. Modules in 4 x 5 cm form factor are fully mechanically and largely electrically compatible among each other.

Key Features

  • Xilinx Kintex UltraScale KU040 FPGA XCKU040-1SFVA784I
  • Rugged for industrial application
  • Size: 40 x 50 mm
  • 3 mm mounting holes for skyline heat spreader
  • 2 banks of 1024 MByte DDR4 SDRAM, 32bit wide memory interface (each DDR 16bit separate)
  • 64 MByte (512 MBit) QSPI Boot Flash
  • B2B Connectors: 3 x Razor Beam High-Speed Hermaphroditic Terminal/Socket Strips (low profile 2.5 mm), total 260 terminals
    • 60 x HR I/Os
    • 84 x HP I/Os
    • Serial transceiver: GTH 8 lanes (TX/RX)
    • 2 x MGT external clock inputs
  • Clocking
    • Si5338 - 4 output PLL, GT and PL clocks
    • 200 MHz LVDS oscillator
  • Power
    • All power supplies on board, single supply operation supported.
    • User defined IO-Bank power
  • Evenly spread supply pins for good signal integrity

Scope of Delivery

  • 1 x TE0841-02-41I21-L Trenz Electronic 4 x 5 cm FPGA module with Xilinx Kintex UltraScale XCKU040, low profile

  產品編號：TE0841-02-41I21-L
  線上商店： 購買連結 可線上刷卡/享運費補助！
Previous Next
Products with Xilinx FPGA

TE0729｜ Xilinx Zynq-7020,3 x Ethernet

TE0729－SoC Module with Xilinx Zynq-7020, 512 MByte DDR3L SDRAM, 3 x Ethernet

The Trenz Electronic TE0729 is an industrial-grade SoC module integrating a Xilinx Zynq-7020 with a Gigabit Ethernet transceiver, 2 x 100 Mbit Ethernet, 512 MByte DDR3L SDRAM, 32 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

All this on a tiny footprint of 5.2 x 7.6 cm at the most competitive price. These high-density integrated modules are smaller than a credit card and available in several variants.

Key Features

  • Zynq XC7Z020-2CLG484I
  • Rugged for shock and high vibration
  • Equipped with sulfur resistant resistors
  • Evenly-spread supply pins for good signal integrity
  • 3 mm mounting holes for Skyline heat spreader
  • 2 x ARM Cortex-A9
  • 1 x 10/100/1000 Mbps Ethernet transceiver PHY
  • 2 x 10/100 Mbps Ethernet transceiver PHYs
  • 3 x MAC-Address EEPROMs
  • 512 MByte (16-bit) DDR3 SDRAM
  • 32 MByte QSPI-Flash memory
  • 8 GByte e.MMC memory
  • USB 2.0 high-speed ULPI transceiver
  • Plug-on module with 2 x 120-pin high-speed hermaphroditic strips
  • 136 FPGA I/O's (58 LVDS pairs possible) and 6 PS MIO's available on board-to-board connectors
  • On-board high-efficiency DC-DC converters
    • 4.0 A x 1.0V power rail
    • 1.5 A x 1.5V power rail
    • 1.5 A x 1.8V power rail
    • 1.5 A x 2.5V power rail
  • System management
  • eFUSE bit-stream encryption
  • AES bit-stream encryption
  • Temperature compensated RTC (real-time clock)
  • User LED
  • size: 5.2 x 7.6 cm
  • Cooling Solution available

Scope of Delivery

  • 1 x TE0729-02-62I63MA Trenz Electronic SoC module with Xilinx Zynq-7020

  產品編號：TE0729-02-62I63MA
  線上商店： 購買連結 可線上刷卡/享運費補助！
Previous Next
Products with Xilinx FPGA

TE0724｜Xilinx Zynq-7000 Series

TE0724 Series－Xilinx Zynq-7000, DDR3L, Flash, Ethernet, EEPROM, CAN(Z-7010, Z-7020)

The Trenz Electronic TE0724 Series is an industrial-grade SoC module integrating a Xilinx Zynq-7010/ Xilinx Zynq-7020 SoC, a Gigabit Ethernet transceiver, 1 GByte DDR3L SDRAM, 64 MByte Flash memory for configuration and operation, and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/Os is provided via a rugged high-speed stacking strip.

All this in a compact 4 x 6 cm form factor, at the most competitive price.

Key Features

  • Xilinx Zynq XC7Z020-1CLG400I
    • Dual-core ARM Cortex-A9 MPCore
    • Max. 667 MHz
  • Rugged for high shock and vibration
  • Dimension: 4 x 6 cm
  • Plug on module with 1 x 160-pin High-Speed connectors
  • 1 GByte DDR3L SDRAM
  • 64 MByte QSPI Flash memory
  • 1 x Gbit Ethernet PHY
  • Total I/O
    PL:80, PS:20
  • 1 x MAC-Adress EEPROM
  • 128 KBit EEProm
  • 1 x CAN transceiver
  • On-board DC/DC regulators
  • Evenly-spread supply pins for good signal integrity

Scope of Delivery

  • 1 x TE0724-04-61I33-A Trenz Electronic SoC module with Xilinx Zynq Z-7020
  • 4 x bolts
  • 8 x screws

  產品編號：

TE0724-04-61I33-A：Xilinx Zynq XC7Z010-1CLG400I

TE0724-04-41I32-A：Xilinx Zynq XC7Z010-1CLG400I

TE0724-04-61I33-A：Xilinx Zynq XC7Z020-1CLG400I

TE0724-04-61I32-A：Xilinx Zynq XC7Z020-1CLG400I
  線上商店： 購買連結 可線上刷卡/享運費補助！
Previous Next
Products with Xilinx FPGA

TE0745｜Xilinx Zynq-7000 Series｜Heat Spreader

TE0745 Series－Xilinx Zynq-7000, DDR3L, Flash, USB, Ethernet, 8 x GTX,Heat Spreader(Z-7030, Z-7045)

The Trenz Electronic TE0745 Series are industrial-grade SoC modules integrating a Xilinx Zynq-7030/ Xilinx Zynq-7045, 1 GByte DDR3L SDRAM, 64 MByte QSPI Flash memory for configuration and operation and powerful switch-mode power supplies for all on-board voltages. A large number of configurable I/O's is provided via rugged high-speed stacking strips.

This module is identical with TE0745-02-71I31-A (replacement for TE0745-02-71I11-A) except the mounted heat spreader.

All this on a tiny footprint of 5.2 x 7.6 cm at the most competitive price. These high-density integrated modules are smaller than a credit card and available in several variants.

Key Features

  • Xilinx Zynq-7000 Series(Z-7030, Z-7045)
  • Rugged for high shock and vibration
  • Size 5.2 x 7.6 cm
  • Dual ARM Cortex-A9 MPCore
  • 1 GByte 32-Bit wide DDR3L
  • 64 MByte QSPI Flash memory
  • 1 GBit Ethernet PHY
  • USB 2.0 OTG PHY
  • Plug-on module with 3 x 160-pin High-Speed Samtec ST5 connectors
  • 250 FPGA I/O's and 6 MIO available on board-to-board connectors
  • 8 x GTX (7030: 4 x GT)
  • 2 GT Reference Clock inputs (7030: 1 REFCLK)
  • 2 x PLL outputs
  • Reference clock input for PLL (optional)
  • I2C
  • MAC Address EEPROM
  • RTC
  • Evenly-spread supply pins for good signal integrity

Scope of Delivery

  • 1 x TE0745-02-71I31-A Trenz Electronic SoM with Xilinx Zynq-7030
  • 1 x mounted heat spreader (article no. KK0745-02)

  產品編號：

TE0745-02-71I31-AK：Xilinx Zynq 7030-1I and Heat Spreader

TE0745-02-92I31-AK：Xilinx Zynq 7045-2I and Heat Spreader

TE0745-02-93E31-AK：Xilinx Zynq 7045-3E and Heat Spreader
  線上商店： 購買連結 可線上刷卡/享運費補助！
  1. TE0823｜Xilinx Zynq UltraScale+ 3CG-L1I
  2. TE0823｜Xilinx Zynq UltraScale+ 3CG-L1I,LP
  3. TE0820｜Xilinx Zynq UltraScale+ ZU Series｜SDRAM
  4. TE0820｜Xilinx Zynq UltraScale+ Series｜ LP

Page 5 of 12