文章

TE0701－Carrier Board for Trenz Electronic 4 x 5 Modules

The Trenz Electronic TE0701 Carrier Board is a base-board for 4 x 5 SoMs, which exposes the module's B2B-connector-pins to accessible connectors and provides a whole range of on-board components to test and evaluate TE 4 x 5 SoMs.

Key Features

• Trenz 4 x 5 Module socket (3 x Samtec LSHM connectors)
• RJ45 GbE Ethernet
• MicroUSB connector (Device, Host or OTG modes)
• SD Card connector - Zynq SDIO0 bootable SD port
• Pmod connector A, 3.3V
  • 6 Pins can be multiplexed to SD Card pins (MIO1 bank when using TE0720)
  • 2 Pins connected to carrier controller CPLD
• Pmod connector B, 3.3V
  • Mapped to 8 PS MIO0 pins if using TE0720 (same mapping as on zedboard)
  • 6 pins also connected to carrier controller CPLD
• Single 12V power supply
• High performance Enpirion DCDC converter for local supplies
• VITA57.1 compliant FMC LPC connector
  • Digitally programmable FMC VADJ power supply
• Carrier controller CPLD
  • 1200 Macrocell CPLD with Block RAM, Flash and PLL
  • 8 user LEDs mappable to different functions
  • 2 user pushbuttons mappable to different functions
  • VID and EN control for FMC VADJ DCDC regulator
• USB JTAG interface
  • Mini USB connector
  • Compatible with Xilinx tools: Impact, Chipscope, XMD, Vivado/SDK etc.
  • Compatible with OpenOCD debugger including ZYNQ SRST control
  • Based on FT2232H USB chip
  • Channel A can toggle module (Zynq PS) reset
  • Channel B can be used as USB UART
    • Carrier controller can reroute RXD/TXD signals
  • JTAG port can be connected to (by the carrier controller)
    • 4 x 5 module JTAG (FPGA + ARM chained in Zynq)
    • 4 x 5 module JTAG and FMC JTAG in chain
    • FMC JTAG alone
    • Zynq ARM PS JTAG port (via EMIO muxing in TE0720)
    • 6 pin header for off board use
    • Pmod connector B for off-board use

Scope of Delivery

• 1 x TE0701-06 carrier board for Trenz Electronic modules with 4 x 5 cm standard footprint only