TEC0330－PCIe FMC Carrier with Xilinx Virtex-7 FPGA, 8 Lane PCIe GEN2, SODIMM SDRAM

The Trenz Electronic TEC0330 is a PCI Express form factor card (PCIe 2.0 or higher) integrating the Xilinx Virtex-7 XC7VX330T FPGA chip. This high-end FPGA card is designed for maximum system performance and intended for use in applications with high demands on system throughput. There is a SO-DIMM socket on the board for standard DDR3 SDRAM extension memory module.

The TEC0330 features HPC (High Pin Count) ANSI/VITA 57.1 compatible FMC interface connector for standard I/O Mezzanine modules. Other interface connectors found on-board include JTAG for accessing FPGA and on-board System Controller CPLD, and also connector with 5 high-speed I/O differential signaling pairs.

Key Features

• Xilinx Virtex-7 FPGA module XC7VX330T-2FFG1157C (commercial temperature range)
• PCI Express 2.0 x8 card with maximum throughput of 4 GB/s
• FMC High Pin Count (HPC) connector
• 8 FPGA MGT lanes available on PCIe interface
• DDR3 SODIMM SDRAM socket
• 256-Mbit (32-MByte) Quad SPI Flash memory (for configuration and operation) accessible through:
  • FPGA
  • JTAG port (SPI indirect, bus width x4)
• External clock input via SMA coaxial connector
• 28 GTH transceivers, each with up to 13.1 Gbit/s data transmission rate
• FPGA configuration through:
  • JTAG connector
  • SPI Flash memory
• Programmable quad clock generator
• TI LMK04828B ultra low-noise JESD204B compliant clock jitter cleaner
• On-board high-efficiency DC-DC converters
• Up to 202 FPGA I/O pins available on FMC connector (up to 101 LVDS pairs possible)
• System management and power sequencing
• AES bit-stream encryption
• eFUSE bit-stream encryption

Scope of Delivery

• 1 x TEC0330-05 Trenz Electronic PCIe FMC Carrier with Xilinx Virtex-7 330T FPGA